HIKVISION DS-3TXX06HP-E Series - Powering on the Device

2.
Hold the SFP opcal module from one side, and smoothly plug
it into the device along with the SFP port slot unl the opcal
module and the device are closely aached.
3.
Aer powering on the device, check the status of LINK/ACT
indicator. If the indicator is lit, the link is connected. If the
indicator is unlit, the link is disconnected. Check the line, and
make sure peer devices have been started.
4 Powering on the Device
Please use the
aached power cord in package to power on the
device.
Before powering your switch, make sure that:
•
The operang power supply is compliant with rated input
standard.
•
Port cables and grounding cables are correctly connected.
•
If there is outdoor cabling, connect a lightning rod and
lightening arrester to the cable.
Cauon
PoE power supply line and strong wire cannot be wired together,
otherwise PD equipment or switch ports will be burnt.
6