Figure 6-11 Add IP Camera
3. Enter network camera parameters.
Use Channel Default Password
If it is enabled, the video recorder will add the camera by the set channel default password.
4. Click Add.
Edit Connected Network Camera
You can edit the IP address, protocol and other parameters of the added network cameras.
Steps
1. Go to Conguraon → Camera → Camera → IP Channel .
2. Click of an added network camera.
Channel Port
If the connected device is an encoding device with
mulple channels, you can choose the
channel to connect by selecng the channel port No. in the drop-down list.
3. Click OK.
Network Video Recorder User Manual
48
To Next Page
Loading...
