Figure 6-4 PPPOE
2.
Turn on Enable.
3.
Enter user name and password.
4.
Click Save.
What to do next
If you can get the dynamic IP, the PPPOE status is normal.
6.2.4 NAT
Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
Before You Start
Enable the UPnP™ funcon of your router if UPnP™ is required. When the device network working
mode is
mul-address, the default device route should be on the same network segment as the
LAN IP address of the router.
Steps
1.
Go to Conguraon → Network → General → NAT .
Digital Video Recorder User Manual
41
To Next Page
Loading...
