HIKVISION DS-7600NI Series User Manual

User Manual of DS-7600NI Series NVR
122
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
DS-7604&7608&7616NI-SE and DS-7600NI-V
DS-7600NI-SE/N, DS-7600NI-SE/P and DS-7600NI-VP
Figure 9. 1 Network Settings Interface
3. In the General Settings interface, you can configure the following settings: NIC Type, IPv4 Address, IPv4
Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP
address and other network settings from that server.
Note: For the DS-7600NI-SE/N, DS-7600NI-SE/P and DS-7600NI-VP series NVR, you need to configure
the internal NIC address, so that IP addresses are assigned to the cameras connected to the PoE or built-in
switch interfaces.
Note: The valid value range of MTU is 500 ~ 9676.
4. After having configured the general settings, click Apply to save the settings.

HIKVISION DS-7600NI Series Specifications

General

Brand	HIKVISION
Model	DS-7600NI Series
Category	Network Hardware
Language	English