HIKVISION DS-7604NI-K1/4P(B) - Manage Cameras for Poe Device; Add Poe Cameras; Add Non-Poe IP Cameras

Network Video Recorder User Manual
49
2.4 Manage Cameras for PoE Device
This chapter is only applicable for the models with PoE interfaces.
Purpose:
Power over Ethernet provides power to a network device via the same cable as used for the
network connection. This is very useful for IP-surveillance and remote monitoring applications in
places where it may be too impractical or expensive to power the device from a power outlet.
The PoE interface supports the Plug-and-Play function. You can manually disable PoE function.
After PoE function is disabled, the PoE channel becomes a normal channel, and online network
camera can be added.
2.4.1 Add PoE Cameras
Step 1 Connect PoE cameras to device PoE interfaces with network cables.
Step 2 Go to Camera > Camera > IP Camera to view camera image and information.
2.4.2 Add Non-PoE IP Cameras
Purpose:
You can manually disable PoE function. After PoE function is disabled, the PoE channel becomes a
normal channel, and online network camera can be added.
Step 1 Go to Camera > Camera > IP Camera.
Step 2 You can add non-PoE IP camera to PoE channel by two ways.
− Manually edit PoE channel parameters.
1) Click of the PoE channel.
2) Select Adding Method as Manual.
− Plug-and-Play: The camera is physically connected to the PoE interface. Its parameters
cannot be edited. You can go to System > Network > TCP/IP to change IP address of PoE
port.
− Manual: Add IP camera without physical connection via network.
3) Manually set the parameters, including IP address, user name, password, etc.