Need help?Do you have a question about the HIKVISION DS-7732NI-K4/16P and is the answer not in the manual?
General| Input bandwidth | 256 Mbit/s |
|---|---|
| Output bandwidth | 160 Mbit/s |
| Maximum resolution | 4096 x 2160 pixels |
| Alarm input channels | 16 |
| Video input channels | 32 channels |
| Alarm output channels | 4 |
| Supported resolutions | 4096 x 2160, 3840 x 2160, 2560 x 1440, 1920 x 1080, 1600 x 1200, 1280 x 1024, 1280 x 720 |
| Audio formats supported | G.711 A-law, G.711 μ-law, G.726 |
| Video formats supported | H.264, H.265, MPEG4 |
| Networking standards | IEEE 802.3af, IEEE 802.3at |
| USB 2.0 ports quantity | 2 |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Power over Ethernet (PoE) | Yes |
| Ethernet LAN (RJ-45) ports | 1 |
| Supported network protocols | TCP/IP, DHCP, IPv4, IPv6, DNS, DDNS, NTP, RTSP, SADP, SMTP, SNMP, NFS, iSCSI, ISUP, UPnP, HTTP, HTTPS |
| HDD capacity | - GB |
| HDD interface | SATA |
| Maximum storage capacity | 8 TB |
| Number of HDDs installed | 0 |
| Certification | FCC Part 15 Subpart B, ANSI C63.4-2014 CE EN 55032: 2015, EN 61000-3-2, EN 61000-3-3, EN 50130-4, EN 55035: 2017 |
| Product color | Black |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 20 W |
| Total Power over Ethernet (PoE) budget | 200 W |
| Operating temperature (T-T) | -10 - 55 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
| Wi-Fi | No |
Weight and Dimensions| Depth | 400 mm |
|---|---|
| Width | 445 mm |
| Height | 75 mm |
| Weight | 5000 g |
Covers initial power-up, shutdown, and device activation procedures.
Guides through the initial setup wizard for essential NVR configuration.
Explains how to add and connect IP cameras to the NVR for surveillance.
Covers setting image quality, resolution, and encoding parameters for recording.
Details how to set schedules for recording and capturing events.
Explains setting up motion detection for triggering recording and actions.
Guides on configuring recording based on alarm inputs.
Explains setting up recording triggered by Video Content Analysis events.
Covers locking recording files and setting HDD properties for data protection.
Describes various methods for playing back recorded video files.
Details methods for backing up recorded files to external devices.
Guides on configuring motion detection alarms and response actions.
Details setting up alarms and actions for video loss detection.
Covers configuring alarms and actions for video tampering detection.
Explains configuring and setting up face detection alarms.
Guides on setting up vehicle detection and license plate capture.
Details configuring line crossing detection rules and sensitivity.
Covers setting up intrusion detection rules, sensitivity, and percentage.
Describes how to search for detected face pictures and related video files.
Covers essential network settings like IP address and working modes.
Details advanced network settings including Hik-Connect, DDNS, and NTP.
Guides on creating and configuring RAID arrays for data redundancy.
Covers the process of initializing newly installed hard disk drives.
Covers S.M.A.R.T. and Bad Sector detection for HDDs.
Details setting up alarms for HDD errors like uninitialized or abnormal status.
Details upgrading NVR firmware via local device or FTP.
Explains how to restore NVR settings to factory defaults.
Offers solutions for common NVR operational issues and errors.
To Next Page
