HIKVISION DS-D2065LU-Y User Manual

• If your LCD display is not working normally, especially if an unusual smell is
emied from the
inside, unplug it immediately and contact your dealer.
• Please note that in addion to the compensaon provided by law, the company is not
responsible for errors caused by customers or third pares when using the machine, and is not
responsible for any other related
malfuncons or damages.
• Do not use the LCD display in environments with large amounts of dust, high humidity, or
possible exposure to oil and water vapor, as this may result in re or damage to the device.
• Do not place the LCD display on an unstable object or in an unsafe place. Do not subject the LCD
display to strong shock or vibraon. If the device is dropped, it may be damaged.
• Do not use the LCD display near heang facilies or any place where there may be high
temperature, as this may cause the machine to overheat and cause a re.
• Before installing the LCD display, please check if your accessories are missing. If there is any
shortage, please contact the seller.
3.3 Power Cord
Connecon
When connecng the power supply, plug one end of the power plug into the power input on the
rear panel of the LCD display, and the other end into a properly grounded power socket (AC 220 V,
50/60 Hz).
In the use of the power cord, the following points should be noted:
• If the LCD display is not to be used for a long
me, shut down the power of the device and
disconnect the power supply.
• Do not damage the power cord. Do not place heavy objects on the power cord, stretch the
power cord, or bend the power cord excessively. If the power cord is damaged, it may cause a
re or electric shock.
• Only use the original power cable delivered with the LCD display. Contact authorized dealer to
purchase power cable with same
specicaons.
• Do not connect DC power.
• Plug the power plug directly into an AC socket. If you add an addional extended power cord,
you may get a
re due to overheang.
• Do not remove or plug in the power plug with a wet hand. It may cause an electric shock.
• Do not
aempt to repair if the power cord is broken or malfunconing. Contact the service
center for repair.
3.4 System
Connecon
The LCD display achieves the video signal from the signal loop video input port (for example, the
DVI-IN), and send the signal to the next unit through the signal loop video output port. The 2 × 2
splicing is taken as an example for
descripon. Follow the wiring method shown in the gure below
to complete the connecon.
LCD Display User Manual
7

HIKVISION DS-D2065LU-Y Specifications

General

Brand	HIKVISION
Model	DS-D2065LU-Y
Category	Monitor
Language	English