HIKVISION DS-K1T673M - Set Wiegand Parameters; Set ISUP Parameters

7.2.4 Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
1.
Tap System → Comm. (Communicaon Sengs) on the Home page to enter the Communicaon
Sengs
page.
2.
On the Communicaon Sengs page, tap Wiegand to enter the Wiegand tab.
3.
Enable the Wiegand
funcon.
4.
Select a transmission direcon.
●
Output: A face
recognion terminal can connect an external access controller. And the two
devices will transmit the card No. via Wiegand 34.
●
Input: A face recognion terminal can connect a Wiegand card reader.
5.
Tap to save the network parameters.
Note
If you change the external device, and aer you save the device parameters, the device will
reboot automacally.
7.2.5 Set ISUP Parameters
Set ISUP parameters and the device can upload data via ISUP protocol.
Before You Start
Make sure your device has connect to a network.
Steps
1.
Tap System → Comm. → ISUP (Communicaon Sengs) on the Home page to enter the sengs
page.
DS-K1T673 Series Face Recognion Terminal User Manual
55