HIKVISION DS-K3BC430LX Series - Page 27

●
Press the Reset buon for 5 s and the device will start to restore to factory sengs.
●
The DIP switch is for study mode seng and keyfob paring. For detailed informaon about the
DIP switch, see DIP Switch Descripon.
The wiring diagram of extended interface of access control board is shown as follows.
Figure 4-5 Wring Diagram of BUS3 Interface
Note
RS-232A corresponds to UART 1 on web.
DS-K3BC430LX Series Swing Gate
15