HIKVISION DS-K3BC430LX Series - 7.5.10 Turnstile Settings

You can enable Verify Credenal Locally. Aer enabling the funcon, the device will only
verify the person's permission without the schedule template, etc.
Access Control Mode
The device works normally and will verify the person's permission to open the barrier.
3.
Set remote vericaon.
1) Enable Remote Vericaon.
Note
The device will upload the person's authencaon informaon to the plaorm. The plaorm
will judge to open the barrier or not.
2) Oponal: Enable Verify Credenal Locally.
Note
Aer enabling the funcon, the device will only verify the person's permission without the
schedule template, etc.
4.
Click Save to complete terminal parameter sengs.
7.5.10
Turnsle
Basic Parameters
Set turnsle basic parameters.
Steps
1.
Click Conguraon → Turnsle → Basic Sengs to enter the page.
2.
View the Device Type, Device Model and Working Status.
3.
Set Barrier Material, Lane Width, Barrier Height, Barrier Opening Speed and Barrier Closing
Speed.
4.
Set the passing mode.
-
If you choose General Passing, you can select the barrier status for the entrance and exit from
the drop-down list.
Note
If you set barrier-free mode, the barrier remains open and will close when authencaon
fails.
-
If you choose Weekly Schedule, you can set a weekly schedule for entrance and exit barriers.
5.
Click Save.
keyfob
Set keyfob patameters.
DS-K3BC430LX Series Swing Gate
43