HIKVISION DS-K3BC430LX Series - Page 54

Steps
Note
Some device models do not support this funcon. Refer to the actual products when conguraon.
1.
Click Conguraon → Access Control → Wiegand Sengs .
2.
Select Entrance or Exit.
3.
Enable Wiegand
funcon.
4.
The wiegand transmission direcon is set Input by default.
Note
Input: the device can connect a Wiegand card reader.
5.
Select Wiegand Mode.
6.
Click Save to save the sengs.
Note
If you change the peripheral, and aer you save the device parameters, the device will reboot
automacally.
Set Terminal Parameters
Set the working mode and remote vericaon.
Steps
1.
Click
Conguraon → Access Control → Terminal Parameters to enter the page.
Figure 7-11 Terminal Parameters
2.
Set the device working mode.
Permission Free Mode
The device will not verify the person's permission, but only the person's validity period. If the
person is in the validity period, the barrier will open.
DS-K3BC430LX Series Swing Gate
42