HIKVISION DS-K3BC430LX Series User Manual

Temperature Unit
Select the temperature unit that displayed in the device status.
Lightboard Brightness
Adjust the brightness of the device light.
Barrier Material
Select the material of the barrier gate. You can select the barrier material from the drop-
down list.
Note
The barrier material may aect the device working. Select a correct barrier material or the
barrier may not open.
Lane Length
The width of the lane. You can set the lane width.
Note
The lane width may aect the device working. Set a correct lane width or the barrier may not
open.
4.
Click OK.
8.7.2
Congure Device Parameters
Aer adding the access control device, you can set its parameters such as network parameters.
Set RS-485 Parameters
You can set the access control device's RS-485 parameters including the baud rate, data bit, the
stop bit, parity type, ow control type, communicaon mode, work mode, and connecon mode.
Before You Start
Add access control device to the client, and make sure the device supports RS-485 interface.
Steps
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon → More Parameters .
3.
Select an access control device in the device list and click RS-485 to enter the RS-485
Sengs
page.
4.
Select the serial port number from the drop-down list to set the RS-485 parameters.
5.
Set the baud rate, data bit, the stop bit, parity type, and
connecon mode in the drop-down list.
6.
Click Save.
●
The
congured parameters will be applied to the device automacally.
●
When you change the connecon mode, the device will reboot automacally.
DS-K3BC430LX Series Swing Gate
72

HIKVISION DS-K3BC430LX Series Specifications

General

Brand	HIKVISION
Model	DS-K3BC430LX Series
Category	Fencing & Gates
Language	English