HIKVISION DS-K3BC430LX Series - Initialize Device

3) Set the conguraon No. in the Level-2 menu to 2. The device will enter the keyfob pairing
mode.
2.
Hold the Close buon for more than 10 seconds.
The keyfob's indicator will
ash if the pairing is completed.
3.
Exit the keyfob pairing mode.
1) Enter the conguraon mode.
2) Set the conguraon No. in Level-1 to 2. The device will enter the keyfob pairing mode.
3) Set the conguraon No. in the Level-2 menu to 1. The device will exit the keyfob pairing
mode.
4.
Reboot the device to take
eect.
4.4.4
Inialize Device
Steps
1.
Hold the
inializaon buon on the access control board for 5 s.
Figure 4-15 Inializaon Buon Posion
2.
The device will start restoring to factory sengs.
3.
When the process is nished, the device will beep for 3 s.
Cauon
The inializaon of the device will restore all the parameters to the default seng and all the
device events are deleted.
Note
Make sure no persons are in the lane when powering on the device.
DS-K3BC430LX Series Swing Gate
23