HIKVISION DS-K3BC430LX Series - Chapter 2 System Wiring; Installation Preparation and Dimensions

Chapter 2 System Wiring
The preparaon before installaon and general wiring.
Steps
Note
●
The device should be installed concrete surface or other at non-ammable surface.
●
If the installaon area is too close to the wall, make sure the distance between the pedestal and
the wall should be no less than 20 mm (40 mm if with face recognion terminals), or you cannot
open the pedestal's top panel or might cause damage to devices.
●
The dimension is as follows.
DS-K3BC430LX Series Swing Gate
3