HIKVISION DS-KD3003-E6 - 7 Configuration Via Client Software; Edit Network Parameters; Add Device; Add Online Device

7 Conguraon via Client Soware
7.1 Edit Network Parameters
To operate and congure the device via LAN (Local Area Network), you need connect
the device in the same subnet with your PC. You can edit network parameters via
iVMS-4200 client soware.
Steps
1.
Select an online acvated device and click the Modify Nenfo.
2.
Edit the device IP address and gateway address to the same subnet with your
computer.
3.
Enter the password and click OK to save the network parameters
modicaon.
Note
•
The default port No. is 8000.
•
The default IP address of the door staon is 192.0.0.65.
•
Aer eding the network parameters of device, you should add the devices
to the device list again.
7.2 Add Device
You should add device to the soware so as to congure the device remotely.
7.2.1 Add Online Device
Before You Start
Make sure the device to be added is in the same subnet with your computer.
Otherwise, please edit network parameters
rst.
Steps
1.
Click Online Device to select an
acve online device.
2.
Click Add.
3.
Enter corresponding informaon, and click Add.
Video Intercom D Series Door
Staon User Manual
53