Need help?Do you have a question about the HIKVISION DS-KD8003 Series and is the answer not in the manual?
General| Ingress Protection | IP65 |
|---|---|
| Operation System | Embedded Linux |
| Camera | 2MP |
| Video Compression Standard | H.264 |
| Resolution | 1920 x 1080 |
| Video Input | 1 channel |
| Video Output | 1 channel |
| Audio Input | Built-in microphone |
| Audio Output | Built-in speaker |
| Audio Compression Standard | G.711 |
| Audio Compression Rate | 64 Kbps |
| Ethernet | 10/100 Mbps |
| Network Protocol | TCP/IP |
| RS-485 | 1 channel |
| Alarm Input | 1 channel |
| Debug Port | 1 channel |
| TF Card | Support up to 128GB |
| Installation | Wall-mounted |
| Power Supply | 12 VDC |
| Working Humidity | 10% to 90% (No Condensation) |
| Network Interface | RJ45 |
| Working Voltage | 12 VDC |
Details the various terminals and interfaces on the main unit for connectivity and power supply.
Provides instructions and diagrams for wiring door locks, door contacts, and exit buttons to the module door station.
Explains the process for installing a single module, covering both surface and flush mounting methods.
Details the installation steps for a two-module configuration, including surface and flush mounting.
Guides through the installation of a three-module setup, covering surface and flush mounting options.
Provides instructions for installing configurations with more than three modules, for both surface and flush mounting.
Describes the procedure for activating the device using a web browser, including initial setup steps.
Explains how to log into the device's web interface for configuration and management.
Details how to access and view the live video feed from the device through the web client.
Guides on adding, editing, and managing user information, including credentials and permissions.
Covers managing linked devices, including adding, importing, exporting, and deleting them.
Outlines various settings that can be configured remotely via the web client for device operation.
To Next Page