HIKVISION DS-KD8003 Series

Time Zone
Select the device located me zone from the drop-down list.
Time Sync.
NTP
You should set the alarm receiver type, NTP server's IP address, port No., and interval.
Manual
By default, the device
me should be synchronized manually. You can set the device me
manually or check Sync. with Computer Time to synchronize the device me with the
computer's me.
6.5.4 Set DST
Steps
1.
Click Conguraon → System → System Sengs → Time Sengs .
2.
Enable DST.
3.
Set the DST start
me, end me and bias me.
4.
Click Save to save the sengs.
6.5.5 View Open Source
Soware License
Click Conguraon → System → System Sengs → About .
Click View Licenses to view the open source code license.
6.5.6 Upgrade and Maintenance
Reboot device, restore device parameters, and upgrade device version.
Reboot Device
Click Conguraon → System → Maintenance → Upgrade & Maintenance .
Click Reboot to start reboot the device.
Restore Parameters
Click Conguraon → System → Maintenance → Upgrade & Maintenance .
Default
The device will restore to the default
sengs, except for the device IP address and the user
informaon.
Restore All
DS-KD8003 Series Module Door Staon User Manual
79