HIKVISION DS-KH9310-WTE1 Configuration Guide

1.
T
ap Sengs →
→ Zone
Sengs to enter the zone sengs page.
Figure 2-7 Zone Sengs
2.
Pr
ess a zone to pop up the zone eding dialogue box.
3.
Se
t the zone type, alarm type, status of arming status, entering delay, and exing
delay.
4.
T
ap OK to save the
sengs.
Note
•
7 z
one types are selectable: Panic
Buon, Door Magnec, Smoke Detector,
Acve Infrared, Passive Infrared, Gas Detector, and Doorbell.
•
3 alarm types are selectable: 24h Alarm, Instant Alarm, and Delay Alarm.
Set the alarm type as 24h alarm, and the zone will be armed for 24h.
Set the alarm type as instant alarm, and the zone will alarm once it's
triggered.
Set the alarm type as delay alarm, and you should set the entering delay
duraon and exing delay duraon.
•
Both the en
tering delay
duraon and the exing delay duraon are from 30s
to 60s.
•
For Gas Detector and Smoke Detector, the alarm type is set as default 24h
alarm. The alarm type of them can not be changed.
Arming Mode Sengs
4 arming modes can be congured: stay mode, away mode, sleeping mode and
cus
tom mode.
Video Intercom 9 Series Indoor Staon
Conguraon Guide
7

HIKVISION DS-KH9310-WTE1 Specifications

General

Brand	HIKVISION
Model	DS-KH9310-WTE1
Category	Intercom System
Language	English