Video Intercom Door Station·User Manual
57
Assigning IP Devices to Group
After adding groups to Community, Outer Door Station, or Other, you should assign
devices to the group.
For example: You should assign indoor stations and door stations to the group 1-1-1 in
Community.
1. Click Add to enter the Add Resident Interface and the video intercom devices added
to the client software will be listed, as shown in the figure below.
Figure 8-17 Adding Resident
2. Check the checkbox of device.
Indoor Station: set a Room No. for the indoor station.
Door Station: set a No. for the door station.
3. Click OK to save the settings.
Assigning Analog Devices to Group
When assigning analog devices to group, only analog indoor stations are supported.
1. Click Add Analog to pop up analog device adding window. You can add analog devices
singly or in batch.
To Next Page
Loading...
Need help?
General
