HIKVISION DS-PDCL12-EG2-WE - Page 5

Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
5
Formang
6
Set up with App
Hold the tamper switch for 8 s and power the device on at the same me. The red LED flashes 3 mes when the formang
operaon is completed.
5
Funcon
Zone Type
Stay Arm Bypass
Chime
Enable Silent Zone
Slide to green to enable the chime.
Slide to green to make the zone keep
silent while alarm is triggered.
Select the zone type of the detector.
Descripon
You can view the device status including temperature, signal intensity, baery level, lid, arming/disarming, etc.,on the device page.
Tap the buon to enter the sengs page.
Double Knock
Slide to green to make the zone alarm
with double knock.
Cross Zone
Slide to green to bypass the zone from
stay arming.
If the alarm triggered in both of the linked
zones within the set me, two alarm
messages will be reported.
Sensivity
Set the sensivity of the detector.
Higher sensivity makes the intruder easier
to be detected.
Swinger limit acvaon
Set the limit mes of swinger acvion .
LED
Turn On/Off the LED.
Polling Rate
Set the interval of heartbeat.
Signal Strength Test
Enter the test mode, and view the LED
indicaon.
Detecon Zone Test
Enter the test mode, and start walk test.
Zone Bypass
By pass the zone.
Sounder Delay Time
Set he sounder delay me up to
Link Camera
Link with a camera for intruder
Find Me
Tap to enter the page and tap Start. The indicator of the
device will then flashes.