HIKVISION DS-PDCL12-EG2-WE - Page 6

7
Specificaon
6
Operaon Cauon and Device Maintenance
- All the electronic operaon should be strictly compliance with the electrical safety regulaons, fire prevenon
regulaons and other related regulaons in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon.
Avoid the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment
damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then
please contact the service center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon.
Avoid the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment
damage).
- Do not place the device in extremely hot (refer to the specificaon of the device for the detailed operaon
temperature), cold, dusty or damp locaons, and do not expose it to high electromagnec radiaon.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low venlaon or heat source such as heater or radiator is forbidden
(ignorance can cause fire danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not
a malfuncon however), and affecng the endurance of sensor at the same me.
- Improper use or replacement of the baery may result in hazard of explosion. Replace with the same or
equivalent type only. Dispose of used baeries according to the instrucons provided by the baery manufactur-
er.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situaon.
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
6
Note: when the low voltage message appears there will be at least 30 days of use.
Detecon Method Passive Infrared
Sensor Model SBG4L46-711
Detecon Range
12m
Detecon Angle
360°
Detecon Zones
172
Detectable Speed
0.3～2m/s
Sensivity
Auto,Low
White Light Filter
6500lux
Digital Temperature Compensaon
Support
Digital Processing Support
Sealed Opcs Support
Tamper Protecon Front,Rear
Environment Temperature Indicator Support
Signal Strength Indicator Support
Power Switch Power Up Enrolling
LED Indicator Blue(Alarm)
Transmission Technology Tri-X Wireless
Transmission Method Two-Way RF Wireless
Transmission Frequency 868 MHz/433 MHz
Transmission Security AES-128 Encrypon
Transmission Range (Open area) 1600 m (868 MHz)/800 m (
433 MHz)
Frequency Hopping Support
Enrolling Method Power up,Remote ID,QR Code
Power Supply Baery Powered
Baery Type CR123A × 1
Typical Voltage 3V
Standard Baery Life 5 years in work status (being triggered 20 mes per day)
Operaon Temperature -10 °C to 55 °C (14 °F to 131 °F)
Storage Temperature -20 °C to 60 °C (-4 °F to 140 °F)
Operaon Humidity 10% to 90%
Dimension (D × D) 101.2 mm x 32.9 mm
Weight 109.5 g
Mounng Height 2.4 to 4m
Mounng Method Ceiling
Applicaon Scenario Indoor
DS-PDCL12-EG2-WE/WB