HIKVISION DS-PHA48-EP User Manual

14
2. Select an area.
3. Set the following parameters according to actual needs.
Enable Auto Arm
Enable the function and set the arming start time. The zone will be armed according to the
configured time.
Note
● The auto arming time and the auto disarming time cannot be the same.
● The buzzer beeps slowly 2 minutes before the auto arming starts, and beeps rapidly 1
minute before the auto arming starts.
● You can select to enable forced arming on the System Options page. While the function is
enabled, the system will be armed regardless of the fault.
Enable Auto Disarm
Enable the function and set the disarming start time. The zone will be disarmed according to
the configured time.
Note
● The auto arming time and the auto disarming time cannot be the same.
Late to Disarm
Enable the function and set the time. If the alarm is triggered after the configured time, the
person will be considered as late.

HIKVISION DS-PHA48-EP Specifications

General

2G standards	GSM
Number of alarm zones	48
Alert notification type	SMS
Connectivity technology	Wired & Wireless
Mobile network generation	4G
Smartphone remote support	Yes
Number of simultaneous users	48 user(s)
Control type	-
Mounting type	Wall
Product color	White
Housing material	Plastic
Number of door/window sensors	- pc(s)
Battery life	36 h
Input voltage	100 - 240 V
Battery voltage	13.5 V
Battery capacity	7000 mAh

Weight and Dimensions

Alarm control panel weight	996.5 g
Alarm control panel dimensions (W x D x H)	261 x 86.4 x 261 mm