HIKVISION DS-PHA48-EP User Manual

32
Scan Adding
Scan peripherals on the bus, and display the scanned peripherals that are not enroll as a list.
Steps
1. Click Device → Scan Adding to enter the page.
2. Select Scan Mode.
Continuous Scan
Add devices from a continuous address range.
Discrete Scan
Add devices from several discrete addresses.
3. Set Address Range or select address.
Note
Please enter a number in the range 0 to 63.
The address range should be continuous.
4. Click Scan Updating to see if there are devices can be added.
Note
The scan takes 1 minute.
If the peripheral and the control panel has different frequency, the peripheral cannot be
enrolled. Click Scan Updating to select the frequency supported by the current control panel.
5. Scanned peripherals will be listed.
6. Tick the checkbox in front of the peripheral. Multiple selection is possible.
7. Click +Enroll to add peripherals.
Note
Up to 32 peripherals can be enrolled.

HIKVISION DS-PHA48-EP Specifications

General

2G standards	GSM
Number of alarm zones	48
Alert notification type	SMS
Connectivity technology	Wired & Wireless
Mobile network generation	4G
Smartphone remote support	Yes
Number of simultaneous users	48 user(s)
Control type	-
Mounting type	Wall
Product color	White
Housing material	Plastic
Number of door/window sensors	- pc(s)
Battery life	36 h
Input voltage	100 - 240 V
Battery voltage	13.5 V
Battery capacity	7000 mAh

Weight and Dimensions

Alarm control panel weight	996.5 g
Alarm control panel dimensions (W x D x H)	261 x 86.4 x 261 mm