70
Set the schedule for the area to automatically arm itself.
Auto Disarm
Enable the area to automatically disarm itself in a specific time point.
Auto Disarm Time
Set the schedule for the area to automatically disarm itself.
Auto Arming Sound Prompt
After disabled, the buzzer will not beep before auto arming.
Late to Disarm
Enable the device to push a notification to the phone or tablet to remind the user to disarm the
area when the area is still armed after a specific time point.
Note
You should enable the Panel Management Notification function on the Web Client of
Communication Parameters → Event Communication before enabling the Late to Disarm
function.
Late to Disarm Time
Set the time point mentioned in Late to Disarm.
Weekend Exception
If enabled, Auto Arm, Auto Disarm, and Late to Disarm are disabled on the weekend.
Holiday Excepted
Enable the function and the zone will not be armed/disarmed in the holiday. You should set the
holiday schedule after enabling.
Note
Up to 6 holiday groups can be set.
3.2.16 Communication
Wired Network
Steps
1. In the site, tap the AX HYBRID PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Wired Network to enter the page.
3. Set the parameters.
– Automatic Settings: Enable DHCP and set the HTTP port.
– Manual Settings: Disabled DHCP and set IP Address, Subnet Mask, Gateway Address, DNS
Server Address.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
