88
-Fault Prompts When Armed: Voice prompt of faults when the system is armed.
-Fault Prompts on Disarming: Voice prompt of faults when disarming
-Fault Prompts When Disarmed: Voice prompt of faults when the system is disarmed.
-Voice Prompts on Alarm: Voice prompt of faults when an alarm is triggered.
System Volume
The available system volume range is from 0 to 10.
Audible Tamper Alarm
While enabled, the system will alert with buzzer for the tamper alarm. Regardless of whether it
is enabled or not, the tamper alarm will be normally pushed to Cloud (for APP) and ARC.
Panel Lockup Button
All functions of AX HYBRID PRO will be frozen after it is enabled. This function can only be
enabled by users with installer permission.
Alarm Duration
Set linked alarm voice prompt lasting time.
Wireless Supervision Loss
Detectors and peripherals whose heartbeat loss times exceed the set value will be shown as
offline.
Bypass on Re-Arm
While enabled, after the detector is bypassed, if its faults are restored and the linked area is
armed, the detector will automatically arm.
Motion Detector Restore
Motion detectors include all PIR detectors.
-Disable: No automatic restore.
-Immediate After Alarm: Motion detectors automatically restores immediately after the alarm
and reports to Cloud (for APP) and ARC.
-After Disarm: Motion detectors automatically restores after disarming and reports to Cloud (for
APP) and ARC
Jamming Sensitivity Settings
The device will detect RF interference and push messages when the RF interference interferes
with communication. You can adjust the detection sensitivity.
Enable PD6662
Enable PD6662 standard. Functions that do not meet the standard will not take effect.
Keypad Logout
After the keypad enters the programming page, if there is no key operation, it will exit the
programming page after reaching this time.
To Next Page
Loading...
