HIKVISION DS-PHA48-EP

90
and APP. If it is not enabled, there will be no fault detection before arming.
Steps
1. On the device list page, tap the AX HYBRID PRO and then log in to the device (if required) to
enter the page.
2. Tap → System → System Options → Arm Options to enter the page.
You can set the following parameters:
Arm with Fault
Check the faults in the Enable Arming with Fault list, and the device will not stop the arming
procedure when faults occurred.
Early Alarm
A delay zone is triggered first, and the area is in the "Entry Delay" stage. During the delay time
period, an instant zone is triggered (only for the first triggered instant zone). At this time, the
area enters the early alarm stage. There are control panel voice alarm and local sounder alarm,
but no alarm message is pushed. If the zone is disarmed or silence before both the early alarm
and entry delay end, the alarm message will not be reported. Otherwise, both the delayed zone
and the instant zone will alarm.
Trigger
Delay Zone
Entry Delay
Trigger
Instant Zone
Early Alarm
Delay Zone & Instant Zone: Alarm
Disarm/Silence
No Alarm
Trigger
Delay Zone
Entry Delay
Trigger
Instant Zone
Early Alarm
Delay Zone & Instant Zone: Alarm
Disarm/Silence
No Alarm
OR
3. Tap Save.
3.3.12 Enrollment Mode
Steps
1. On the device list page, tap the AX HYBRID PRO and then log in to the device (if required) to
enter the page.
2. Tap → System → System Options → Enrollment Mode to enter the page.
3. Tap Enter the Enrollment Mode. You can enroll the peripheral by triggering it.