HIKVISION DS-PS1-I-WB

To Next Page

To Previous Page

2. Select the Alarm Receiver Center as 1 or 2 for configuration, and slide the slider to enable the

selected alarm receiver center.

Note

Only if the alarm receiver center 1 is enabled, you can set the alarm receiver center 2 as the

backup channel and edit the channel parameters.

3. Select the Protocol Type as ADM-CID, ISUP, SIA-DCS, *SIA-DCS, *ADM-CID, CSV-IP, or FSK

Module to set uploading mode.

HIKVISION DS-PS1-I-WB - Page 70