Parking Camera User Manual
vi
Safety Instruction
Laws and Regulations
Use of the product must be in strict compliance with the local laws and regulations. Please shut
down the device in prohibited area.
Power Supply
● Use of the product must be in strict compliance with the local electrical safety regulations.
● Use the power adapter provided by qualified manufacturer. Refer to the product specification
for detailed power requirements.
● It is recommended to provide independent power adapter for each device as adapter overload
may cause over-heating or a fire hazard.
● Make sure that the power has been disconnected before you wire or install the device.
● To avoid electric shock, DO NOT directly touch exposed contacts and components once the
device is powered up.
● DO NOT use damaged power supply devices (e.g., cable, power adapter, etc.) to avoid electric
shock, fire hazard, and explosion.
● DO NOT directly cut the power supply to shut down the device. Please shut down the device
normally and then unplug the power cord to avoid data loss.
● DO NOT block the power supply equipment to plug and unplug conveniently.
● Make sure the power supply has been disconnected if the power adapter is idle.
● Make sure the device is connected to the ground firmly.
Transportation, Use, and Storage
● To avoid heat accumulation, good ventilation is required for a proper operating environment.
● Store the device in dry, well-ventilated, corrosive-gas-free, no direct sunlight, and no heating
source environment.
● Avoid fire, water, and explosive environment when using the device.
● Avoid lightning strike for device installation. Install a lightning arrester if necessary.
● Keep the device away from magnetic interference.
● Avoid device installation on vibratory surfaces or places. Failure to comply with this may cause
device damage.
● DO NOT touch the heat dissipation component to avoid burns.
● DO NOT expose the device to extremely hot, cold, or humidity environments. For temperature
and humidity requirements, see device specification.
Maintenance
● If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the
power cable, and contact the service center.
● If the device cannot work properly, contact the store you purchased it or the nearest service
center. DO NOT disassemble or modify the device in any way (For the problems caused by
unauthorized modification or maintenance, the company shall not take any responsibility).
To Next Page
Loading...