Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
70
11.4.7 Day/Night Switch
Day/Night Switch function can provide color images in the day mode and black/white images in
the night mode. Switch mode is configurable.
Day
The image is always in color.
Night
The image is always black/white
Auto
The camera switches between the day mode and the night mode according to the illumination
automatically.
Scheduled-Switch
Set the Start Time and the End Time to define the duration for day mode.
Note
Day/Night Switch function varies according to models.
11.4.8 Set Supplement Light
Steps
1. Go to Configuration → Maintenance → System Service.
2. Check Enable Supplement Light.
3. Click Save.
Set Laser Parameters
You can enable the laser supplement and adjust the laser supplement angle to improve the image
effect.
Before You Start
Check Enable Supplement Light first before you configure this function.
Steps
1. Go to Configuration → System → Maintenance → System Service.
2. Select Laser Optical Axis Adjustment from the drop-down list.
3. Check Enable Laser Optical Axis Adjustment.
4. Adjust the optical zoom ratio to the maximum value via PTZ control panel.
5. Click the direction buttons to adjust the position of laser.
6. Adjust the sensitivity. The higher the value is , the faster the cursor moves.
7. Click Save when the laser point is in the center of live view.
To Next Page
Loading...
Need help?
General
