Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
15
appropriate scene.
Fire source detection can be applied to indoor and outdoor monitoring with a maximum detection
radius 15 km. To achieve the best monitoring effect, please set the installation place as
requirements below.
● The installation place should be the highest position within the detection area. The lens should
not be covered during movement to detect the maximum area.
● It is better to choose the installation place with convenient traffic, well-equipped power and
internet facilities. E.g. communication tower, watchtower, high-rise roof and so on.
4.3 Detection Mode and Application Scene
Fire and Smoke Detection Mode
Fire or Smoke
The system alarms when device is either triggered by fire source detection or smoke detection.
Fire and Smoke
The system holds when device is triggered by fire source detection or smoke detection. When
target is detected by both rules, the system sends two alarms, otherwise, the system sends
single alarm.
Double Confirm
The system alarms when device is both triggered by fire source detection and smoke detection.
Specified Fire Source
The system alarms when device is triggered by fire source detection.
Specified Smoke
The system alarms when device is triggered by smoke.
Application Scene
In Application Scene, Short Distance and Long Distance are selectable. Select the scene according
to the actual monitoring distance.
4.4 Set the Presets
Please set the presets according to steps below to improve the accuracy of fire detection.
Steps
1. If the presets located in different areas, you can set 6 presets in two areas as the example
showed below.
To Next Page
Loading...
Need help?
General
