Network Camera User Manual
153
counting accuracy, make sure your camera is installed horizontally.
Steps:
1. Enter the Counting Configuration interface: Configuration > People Counting.
People Counting Configuration
2. Check Enable People Counting checkbox to enable the function.
3. Set the detection line.
An orange line, named as detection line can be set on the live video, and the
object entering or exiting through the line will be detected and counted.
• Click button on the left of the live view image. An orange line will
appear on the image.
• Drag the detection line to adjust its position.
• Drag the yellow end points of the detection line to adjust its length.
Note:
• The detection line should be drawn at the position right below the
camera, and it should cover the whole entrance/exit.
To Next Page
Loading...
Need help?
General
