Network Camera User Manual
130
You can press the Emergency button on the remote control to trigger the Emergency
Alarm in case of an emergency.
Note: The remote control is required for the Emergency Alarm. Go to Configuration >
System> System Settings > Remote Control to study the remote control first.
Steps:
1. Enter the Emergency Alarm Settings interface:
Configuration > Event > Basic Event> Emergency Alarm
Setting Emergency Alarm
2. Check the checkbox to select the linkage methods taken for the Emergency alarm.
3. Click Save to save the settings.
Smart Events
You can configure the smart events by following the instructions in this section,
including audio exception detection, defocus detection, scene change detection,
intrusion detection, and line crossing detection, etc. These events can trigger the
linkage methods, such as Notify Surveillance Center, Send Email, Trigger Alarm
Output, etc.
Configuring Audio Exception Detection
Purpose:
To Next Page
Loading...
Need help?
General
