Network Video Recorder User Manual
62
Quick access to the sub-menus which you frequently visit.
Enter the main menu of the system by right clicking the mouse.
Switch to the single full screen by choosing channel number
from the dropdown list.
Adjust the screen layout by choosing from the dropdown list.
Switch to the previous screen.
Switch to the next screen.
Enable/disable the auto-switch of the screens.
Start continuous recording or motion detection recording of
all channels.
Enter the IP Camera Management interface, and manage the
cameras.
Enter the playback interface and start playing back the video
of the selected channel immediately.
Enter the PTZ control interface.
Four modes of output supported, including Standard, Bright,
Gentle and Vivid.
Switch to the auxiliary output mode and the operation for the
main output is disabled.
The dwell time of the live view configuration must be set before using Start Auto-switch.
If you enter Aux monitor mode and the Aux monitor is not connected, the mouse operation
is disabled; you need to switch back to the Main output with the MAIN/AUX button on the
front panel or remote.
If the corresponding camera supports intelligent function, the Reboot Intelligence option is
included when right-clicking mouse on this camera.
To Next Page
Loading...
Need help?
General
