HIKVISION iDS-TCM403-AI - Configure TCP;IP Settings

Network Traffic Camera User Manual
25
serial device will be controlled remotely by the computer through the
network.
Steps:
1. Go to Configuration > Device Configuration > System Configuration > Serial
Ports.
Figure 8-3 Serial Ports Settings
2. Configure the RS-485 and RS-232 parameters.
3. Click Save to save the settings.
8.4 Configure TCP/IP Settings
Purpose:
TCP/IP settings must be properly configured before you operate the camera over
network.
Steps:
1. Go to Configuration > Device Configuration > System Configuration >
TCP/IP.