HIKVISION iDS-TCV500-BI User Manual

Network Traffic Camera • User Manual
24
Set the following parameters.
 HTTP Port: The default port number is 80, and it can be changed to any port No. ranges from 1
to 65536 which is not occupied, except 21 (FTP port) and 23 (Telnet port).
 RTSP Port: The default port number is 554 and it can be changed to any port No. ranges from
1 to 65536 which is not occupied, except 21 (FTP port) and 23 (Telnet port).
 SDK Port: The default server port number is 8000, and it can be changed to any port No.
ranges from 2000 to 65535 which is not occupied.
 SADP Port: Enable the function, and devices can be searched via SADP. It is enabled by default.
Click Save to save the settings.
Set DDNS
Purpose:
When the external network of the device is a dynamic IP address, you can use DDNS domain name
for remote access.
Before you start:
 Register the relevant domain name.
 LAN IP address, subnet mask, gateway, and DNS server have been set.
Go to Configuration > Device Configuration > System Configuration > DDNS.
DDNS Settings
Check Enable DDNS.
Select DDNS Type.
Enter Server Address (the server address of the registered domain name) and Device
Domain Name.

HIKVISION iDS-TCV500-BI Specifications

General

Card reader integrated	Yes
Maximum memory card size	128 GB
Maximum resolution	2464 x 2056 pixels
Image quality adjustment	Saturation, Brightness, Contrast, Sharpness, DNR
Video compression formats	H.264, H.265
Placement supported	Outdoor
Signal-to-Noise Ratio (SNR)	60 dB
Number of users	32 user(s)
Supported network protocols	TCP/IP, HTTP, HTTPS, FTP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, IPv6, UDP
Focus	Motorized/Manual
Minimum illumination	0.001 lx
Housing material	Aluminum
International Protection (IP) code	IP66