HIKVISION iVMS-4200 User Manual

Network Camera User Manual
29
1. Check the checkbox of to enable WPS.
2. Choose the connection mode as PBC.
Note: Support of this mode is mandatory for both the Access Points and the
connecting devices.
3. Check on the Wi-Fi router to see if there is a WPS button. If yes push the button
and you can see the indicator near the button start flashing, which means the WPS
function of the router is enabled. For detailed operation, please see the user guide of
the router.
4. Push the WPS button to enable the function on the camera.
If there is not a WPS button on the camera, you can also click the virtual button to
enable the PBC function on the web interface.
5. Click Connect button.
When the PBC mode is both enabled in the router and the camera, the camera and the
wireless network is connected automatically.
PIN Mode:
The PIN mode requires a Personal Identification Number (PIN) to be read from either
a sticker or the display on the new wireless device. This PIN must then be entered to
connect the network, usually the Access Point of the network.
Steps:
1. Choose a wireless connection on the list and the SSID is loaded automatically.
2. Choose Use route PIN code.
Figure 4-10 Use PIN Code

HIKVISION iVMS-4200 Specifications

General

Max. Number of Devices	256
Supported OS	Windows
Compatible Devices	Hikvision IP Cameras, DVRs, NVRs
Features	Alarm Management
Multi-Screen Display	Yes
Remote Access	Yes
Storage Options	NAS
Language Support	Multiple languages