Network Camera User Manual
70
Note: The display parameters vary according to the different camera models. Please
refer to the actual interface for details.
9.1.1 Day/Night Auto-Switch
Steps:
1. Enter the Display Settings interface, Configuration > Advance Configuration >
Image > Display Settings.
Figure 9-1 Display Settings of Day/Night Auto-Switch
2. Set the image parameters of the camera.
Note: In order to guarantee the image quality in different illumination, it provides two
sets of parameters for users to configure.
Brightness describes bright of the image, which ranges from 1 to 100.
Contrast describes the contrast of the image, which ranges from 1 to 100.
Saturation describes the colorfulness of the image color, which ranges from 1 to
100.
To Next Page
Loading...
