194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use Page 91
Decontamination,
Maintenance
Recommended Materials and Products
A list of recommended cleaning products for all types of cleaning requirements
is available on your request along with a special maintenance advice leaflet.
• Single-use tissues or recyclable textile wipers.
• One pair of household gloves.
• Detergent-disinfectant solution diluted according to hospital guidelines (and
taking into account the recommendations given below) or a disinfecting
spray.
• Use a product that complies with standard EN 14885 (bactericide including
TB, fungi and viruses, including HIV-1 and HBV).
• Chlorine-based products (26000 ppm) that comply with the standard EN
13727 and EN 13624 can be used, but may cause discoloring. Bare metal
parts must be rinsed to prevent corrosion.
The following products should not be used.
Formaldehyde, phenol-based products and solvents of any kind (toluene, xylene
or acetone).
Never use abrasives, cleaning powder or cleaning pads that may damage
components.
Recommended Cleaning and Disinfection Method
• Always wipe downward, working from the cleanest to the dirtiest areas.
•Do not scrape surfaces.
• Keep wipes damp (wet as many times as needed and do not wring out too
much water).
• Let product dry according to disinfectant manufacturer's recommendations to
ensure maximum efficiency.
• If necessary, rinse according to the disinfectant product manufacturer's
recommendations.
• Change wipes when cleaning the least contaminated areas to areas of
medium or to highly contaminated areas.
• Change wipes when cleaning another bed.
• Always dry the bed thoroughly after it has been cleaned.
Cleaning tough stains
Quickly wipe away any traces of pharmaceutical solutions or other staining
products in order to avoid permanent damage to the surface.
To remove tough stains, use standard household cleaners and a soft bristle brush.
To loosen heavy, dried-on soil or excreta, you may first need to saturate the spot.
To Next Page
Loading...
