EasyManuals Logo

Hilti C7 Original Operating Instructions

Hilti C7
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
6 English
4.2 Temperature specifications
Battery charging starting temperature
−10 …45
Storage temperature
−20 …40
Ambient temperature for operation
−17 …60
4.3 Battery charging times
Voltage Battery type Charging time
7.2 V B 7/1.5 Li-Ion 45 min
7.2 V B 7/2.0 Li-Ion 60 min
5 Operation
5.1 Switching the charger on
Plug the supply cord into the power outlet.
LED 1 on the charger lights up green.
5.2 Charging the battery
1. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
A list of the batteries approved for use with this product can be found at the end of this document.
2. Push the battery into the interface of the charger. Check that the encoding of the battery and charger
interface match.
Charging begins automatically after insertion of the battery in the charger. The state of charge
indicator on the battery is deactivated during charging.
The battery will suffer no damage when left in the charger for long periods.
For safety reasons, the battery should, however, be removed from the charger after completion of
charging.
5.3 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.4 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
6 Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
Always unplug the supply cord before carrying out care and maintenance tasks.
Care
Carefully remove any dirt that may be adhering to parts.
Clean the air vents carefully with a dry brush.
Printed: 03.12.2018 | Doc-Nr: PUB / 5069444 / 000 / 02

Other manuals for Hilti C7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hilti C7 and is the answer not in the manual?

Hilti C7 Specifications

General IconGeneral
BrandHilti
ModelC7
CategoryBattery Charger
LanguageEnglish

Related product manuals