16
General
warning
Warning:
electricity
Warning: hot
surface
Obligation signs
Symbols
On the drill stand On the tool
Wear eye
protection
Wear a safety
helmet
Wear ear
protection
Wear safety
gloves
Wear safety
boots
1. General information
1.1 Indication of danger
-CAUTION-
Used to draw attention to a potentially dangerous situ-
ation which could lead to minor personal injury or dam-
age to the equipment or other property when the given
safety precautions are not observed.
1.2 Pictograms
Warning signs
Top
An additional means of secur-
ing the drill stand must be
employed when used for hori-
zontal drilling with vacuum
attachment.
Bottom
The drill stand must be fas-
tened by means of an anchor
or quick-release brace when
used for overhead drilling.
Use of the water collector
system in conjunction with a
wet-type vacuum cleaner is
mandatory when working
overhead on ceilings.
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cov-
er pages. Keep these pages open while studying the
operating instructions.
In these operating instructions, the DD 130 core drilling
machine is referred to as "the tool".
Location of identification data on the tool
The type designation and serial number can be found
on the rating plate on the tool. Make a note of this data
in your operating instructions and always refer to it when
making an enquiry to your Hilti representative or ser-
vice department.
Type: DD130
Serial no.:
Read the operating
instructions before use.
Return waste material
for recycling.
To Next Page
Loading...
Need help?
General
