Hilti DX 9–ENP User Manual

8 English 2194400
*2194400*
3.9 Requirements to be met by cartridges
WARNING
Risk of injury by unexpected explosion! Use of cartridges that do not meet the minimum safety
requirements can lead to a build-up of unburned powder. A sudden explosion and severe injuries to the
operator and bystanders can result.
▶ Use only cartridges that meet the minimum safety requirements of your local statutory regulations!
▶
Adhere to the maintenance intervals as stated and have the fastening tool cleaned regularly by Hilti-
Service!
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
• It is a requirement for EFTA countries that the cartridges must be CE-compliant and must bear the CE
mark of compliance.
• It is a requirement for the United Kingdom that the cartridges must be UKCA-compliant and must bear
the UKCA mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
Cartridges
Item number Ordering designation Annotation
2128213 6.8/18 M40 black very strong
2128211 6.8/18 M40 red strong
3.10 Items supplied
Fastening tool, toolbox, cleaning set, scraper, ramrod, Hilti lubricant spray, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
4.1 Technical data
DX 9–ENP
Weight
27.6 lb
(12.5 kg)
Dimensions (L × W × H)
38.8 in × 14.4 in × 6.9 in
(985 mm × 365 mm × 175 mm)
Magazine capacity
40 nails / 40 cartridges
Suitable cartridges
6.8/18 M40 red, black, blue
Suitable fasteners
XENP 19
Fastener driving rate
0.333 Hz
(1,200 rev/h)
Thickness of the supporting steel
≥ 0.2 in
(≥ 6 mm)
Compression stroke
3.5 in
(89 mm)
Contact pressure
≥ 56 lb
f
… < 74 lb
f
(≥ 250 N … < 330 N)
Application temperature (ambient temperature)
5 ℉ … 122 ℉
(−15 ℃ … 50 ℃)

Hilti DX 9–ENP Specifications

General

Brand	Hilti
Model	DX 9–ENP
Category	Power Tool
Language	English