*2068470*
2068470 English 3
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Laser range meter PD-E
Generation 01
Serial no.
1.5 Laser information on the product
Laser information → page 3
Laser information
Laser Class 2 based on the IEC60825-1 / EN60825-
1:2007 standard in compliance with CFR 21 § 1040
(Laser Notice 50).
Laser Class 2: Do not stare into the beam. Do not di-
rect the beam toward other persons or toward areas in
which other persons, who are not involved in the work
with lasers, may be present.
Recycle waste material.
2 Safety
2.1 Safety instructions
2.1.1 Basic information concerning safety
In addition to the safety rules listed in the individual sections of these
operating instructions, the following rules must be strictly observed at
all times. The product and its ancillary equipment may present hazards
when used incorrectly by untrained personnel or when used not as directed.
▶ Keep all safety instructions and information for future reference.
▶ Stay alert, watch what you are doing and use common sense when
working with the product. Do not use the product while you are tired
or under the influence of drugs, alcohol or medication. A moment of
inattention while operating the product may result in serious personal
injury.
▶ Do not render safety devices ineffective and do not remove information
and warning notices.
▶ If the product is opened improperly, laser radiation in excess of Class 2
may be emitted. Have the product repaired only by Hilti Service.
▶ Tampering with or modification of the product is not permitted.
▶ Check that the product functions correctly each time before use.
To Next Page
Loading...
