Hilti pd-e - General Safety Rules and Practices; 2.1.2 General safety rules; 2.1.3 Proper preparation of the working area; 2.1.4 Working safely with laser tools

4 English 2068470
*2068470*
▶ Measurements taken through panes of glass or other objects may be
inaccurate.
▶ The measurement may be incorrect if the conditions under which the
measurement is taken change rapidly, e.g. due to people walking through
the path of the laser beam.
▶ Do not point the product toward the sun or other powerful light sources.
▶ Take the influences of the surrounding area into account. Do not use the
tool where there is a risk of fire or explosion.
▶ Observe the information printed in the operating instructions concerning
operation, care and maintenance.
2.1.2 General safety rules
▶ Check the product for damage before use. Have the damage repaired
by Hilti Service.
▶ Check the accuracy of the product after it has been dropped or subjected
to other mechanical stresses.
▶ Although the product is designed for the tough conditions of jobsite use,
as with other measuring instruments it should be treated with care.
▶ Products which are not in use must be stored in a dry, high place or
locked away out of reach of children.
▶ The product is not intended for use by children.
▶ Observe the national health and safety requirements.
2.1.3 Proper preparation of the working area
▶ Avoid unfavorable body positions when working from ladders. Make
sure you have a safe stance and that you stay in balance at all times.
▶ Secure the site at which you are taking measurements and take care to
avoid directing the laser beam toward other persons or toward yourself.
▶ When the product is brought into a warm environment from very cold
conditions, or vice-versa, allow it to become acclimatized before use.
▶ Use the product only within its specified limits.
▶ Keep the laser exit window clean in order to avoid measurement errors.
▶ Observe the accident prevention regulations applicable in your country.
2.1.4 Working safely with laser tools
▶ Laser Class 2/Class II tools may be operated only by appropriately
trained persons.
▶ Laser beams should not be projected at eye height.
▶ Precautions must be taken to ensure that the laser beam does not
unintentionally strike highly reflective surfaces.
▶ Precautions must be taken to ensure that persons do not stare directly
into the beam.
▶ The laser beam must not be allowed to project beyond the controlled
area.
▶ Switch the laser tool off when it is not in use.