8 English
1. Short-press the Bluetooth button.
2. To pair the appliance manually for the first time, press and hold down the Bluetooth button (for about 2
seconds) until the Bluetooth symbol starts to flash.
◁
Select the Hilti Radio Charger on the external device while the Bluetooth symbol on the display is
flashing.
◁ The devices have been successfully paired when the Bluetooth and pairing symbols both show
continuously in the display.
3. Press the Bluetooth button if the appliance is already paired.
◁ Pairing starts automatically and the pairing symbol on the screen starts to flash.
◁ The appliance searches for a signal for a maximum of 3 minutes.
◁ The pairing symbol appears in the display to indicate that the devices are paired.
◁ The Bluetooth symbol appears in the display to indicate that the appliance has found a paired external
device.
5.7 Making an NFC connection
1. Activate the NFC function on your mobile device (if it supports NFC).
2. Hold you mobile device close to the NFC interface of the appliance. This is on the right-hand side and is
indicated by the NFC symbol.
Note
You must accept the NFC connection at your mobile device when the connection is established
for the first time.
5.8 Setting the audio source
Note
Press the mode button to select the audio source: AM, FM, AUX or Bluetooth.
Printed: 03.03.2017 | Doc-Nr: PUB / 5296538 / 000 / 01
To Next Page
Loading...
Need help?
General
