Hilti SF 2-A12 - Selecting gear, torque, and rotation; Screwdriving and Drilling Modes

12 English 2235450
*2235450*
4. Check that the accessory tool is held securely.
6.2 Selecting the gear 4
The gear selector switch can be operated only when the motor is not
running.
▶
Select the gear.
6.3 Setting the torque
▶ Set the desired torque.
➥ The torque is limited only when the power tool is set to screwdriving
mode .
6.4 Setting forward or reverse rotation 5
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
➥ An interlock prevents switching while the motor is running. In the middle
position the switch is locked (safety lock).
6.5 Selecting the function 3
SF 2HA12
▶ Select the desired function.
6.6 Screwdriving
1.
Set the function selector ring to the “screwdriving” position .
2. Set the torque setting ring to the desired torque.
3. Set the forward/reverse switch to the desired direction of rotation.
6.7 Drilling
1. Set the function setting ring/torque setting ring to the “drilling” position
.
2. Set the forward/reverse switch to the “forward” position.
Printed: 19.09.2019 | Doc-Nr: PUB / 5509387 / 000 / 01