Hilti SF 2-A12 User Manual

*2235450*
2235450 English 9
Battery charge status cannot be displayed while the control switch is
pressed.
3.4 Overload and overheating protection
The power tool is equipped with an electronic system to protect against
overloading and overheating. The power tool switches itself off automatically
in the event of overloading or overheating. After releasing the control switch,
the power tool may not restart immediately when the switch is pressed again
(while the power tool is cooling down).
Overloading or overheating are not indicated by the charge status
display.
3.5 Items supplied
(Hammer) drill / driver, operating instructions.
To help ensure safe and reliable operation, use only genuine Hilti spare
parts and consumables. Other system products approved for use with
this product can be found at your local Hilti Store or at: www.hilti.group
4 Technical data
4.1 Technical data
SF 2-A12 SF 2H-A12
Rated voltage
10.8 V 10.8 V
Weight
1.1 kg
(2.4 lb)
1.2 kg
(2.6 lb)
Speed 1st gear
0 /min …
400 /min
0 /min …
400 /min
2nd gear
0 /min …
1,560 /min
0 /min …
1,560 /min
Torque (soft joint)
≤ 21 Nm
(≤ 15 ftlb
f
)
≤ 21 Nm
(≤ 15 ftlb
f
)
Torque range (15 settings)
0.5 Nm … 5 Nm
(0.4 ftlb
f
…
4 ftlb
f
)
0.5 Nm … 5 Nm
(0.4 ftlb
f
…
4 ftlb
f
)
Keyless chuck clamping range
0.8 mm …
10 mm
(0.03 in … 0.4 in)
0.8 mm …
10 mm
(0.03 in … 0.4 in)
Ø drill bit (softwood)
3/64 in …
35/64 in
3/64 in …
35/64 in
Printed: 19.09.2019 | Doc-Nr: PUB / 5509387 / 000 / 01

Hilti SF 2-A12 Specifications

General

Battery Voltage	12 V
Battery Type	Li-ion
Weight	1.1 kg
Dimensions (L x W x H)	190 mm
Chuck Type	Keyless