10 English 2041323
*2041323*
preliminary assessment of exposure. The data given represents the main
applications of the power tool. However, if the power tool is used for different
applications, with different accessory tools, or is poorly maintained, the data
can vary. This can significantly increase exposure over the total working
period. An accurate estimation of exposure should also take into account
the times when the power tool is switched off, or when it is running but not
actually being used for a job. This can significantly reduce exposure over
the total working period. Identify additional safety measures to protect the
operator from the effects of noise and/or vibration, for example: maintaining
the power tool and accessory tools, keeping the hands warm, organization
of work patterns.
SF 14-A SFH 14-A
Typical A-weighted sound power level
86 dB 102 dB
Typical A-weighted emission sound
pressure level
75 dB 91 dB
Uncertainty for the given sound levels
3 dB 3 dB
Vibration emission value for screwdriv-
ing (a
h
)
2.5 m/s² 2.5 m/s²
Uncertainty (K
h
)
1.5 m/s² 1.5 m/s²
Hammer drilling in masonry (max. length
100 mm)
•/• 4 mm …
12 mm
Uncertainty (K)
1.5 m/s² 1.5 m/s²
Vibration emission value for drilling in
metal (a
h, D
)
2.5 m/s² 2.5 m/s²
Uncertainty (K)
1.5 m/s² 1.5 m/s²
5 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
To Next Page
Loading...
Need help?
General
