Hilti SFC 14-A Original Operating Instructions

*440881*
440881 English 17
5.4 Fitting the belt hook (optional) 2
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself and others.
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
▶ Fit the belt hook.
5.5 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
5. Check that the accessory tool is held securely.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Selecting the gear 3
▶ Select the gear.
6.2 Setting forward or reverse rotation 4
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Switching on
▶ Press the control switch.
Speed can be controlled steplessly right up to maximum by varying how far the control switch is
pressed in.
6.4 Screwdriving
1. Set the torque and operating mode selector ring to the required torque.
2. Set the forward/reverse switch to the desired direction of rotation.
6.5 Drilling
1.
Set the torque and operating mode selector ring to the symbol.
2. Set the forward/reverse switch to the “forward” position.
6.6 Switching off
▶ Release the control switch.
6.7 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Open the keyless chuck.
Printed: 18.09.2019 | Doc-Nr: PUB / 5071588 / 000 / 07

Hilti SFC 14-A Specifications

General

Number of gears	2
Screw diameter (max)	8 mm
Sound pressure level	69 dB
Idle speed (1st gear)	1700 RPM
Drilling diameter in wood (max)	20 mm
Drilling diameter in steel (max)	10 mm
Vibration level (metal drilling)	2 m/s²
Maximum torque (hard applications)	45 N⋅m
Maximum torque (soft applications)	24 N⋅m
Product color	Black, Red
Chuck type	Keyless
Product design	Pistol grip drill
Number of batteries included	1 pc(s)
Power source	Battery
Battery voltage	14 V

Weight and Dimensions

Weight	1500 g