*2253585*
2253585 English 7
SSHCS,
0.5 1.5 mm,
, for
straight cuts
SSHCS,
1.5 2.5 mm,
, for
straight cuts
SSHCX,
0.5 1.5 mm,
, for
straight cuts
in stainless
steel
SSHCC,
0.5 1.5 mm,
, for curves
SSHCD,
4 x 0.9 mm,
, for spiral
ducting
Permissible steel
thickness, steel
up to 400 N⁄mm²
1.5 mm 2.5 mm •/• 1.5 mm •/•
Permissible steel
thickness, steel
up to 600 N⁄mm²
1.0 mm •/• 1.5 mm 0.8 mm •/•
Permissible ma-
terial thickness,
aluminum up to
250 N⁄mm²
2.0 mm 3.0 mm •/• 2.0 mm •/•
Permissible
material
thickness, steel
spiral ducting up
to 400 N⁄mm²
•/• •/• •/• •/• 4 x 0.9 mm
Permissible
material
thickness, steel
spiral ducting up
to 600 N⁄mm²
•/• •/• •/• •/• 4 x 0.6 mm
Starting hole di-
ameter
17 mm 22 mm 20 mm 15 mm 18 mm
Smallest radius
for curved cut-
outs
80 mm 150 mm 120 mm L 45 mm,
R 80 mm
150 mm
5 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
To Next Page
Loading...
Need help?
General
