Hilti TE 2-A22 Operating Instructions

2 English 2023934
*2023934*
1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols can be used on the product:
Drilling without hammer action
Drilling with hammering action (hammer drilling)
Forward / reverse
Rated speed under no load
Revolutions per minute
Direct current (DC)
Li-ion battery
Hilti Li-ion battery type series used. Observe the information given in the section headed In-
tended use.
Never use the battery as a striking tool.
Do not drop the battery. Never use a battery that has suffered an impact or is damaged in any
other way.
The power tool supports near-field communication (NFC) technology, which is compatible with
iOS and Android platforms.
1.4 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Type: TE 2-A22
Generation: 02
Serial no.:
1.5 Declaration of conformity
We declare, onour sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistraße 6 | 86916 Kaufering, DE
2 Safety
2.1 General power tool safety warnings
WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Work area safety
▶ Keep work area clean and well lit. Cluttered or dark areas invite accidents.

Hilti TE 2-A22 Specifications

General

Power source	Battery
Battery voltage	21.6 V
Impact rate	5040 bpm
Rated speed (max)	1090 RPM
Impact energy (max)	1.5 J
Vibration level (hammer drilling)	15 m/s²
Product color	Black, Red
Built-in light	Yes
Noise level	92 dB

Weight and Dimensions

Weight	2700 g